Skip to content

Fabrication of Complex Three-Dimensional Structures of Mica through Digital Light Processing-Based Additive Manufacturing

Document Type
Publications · Journal Article
Registered DB
ESCIScopus
Journal Ranking
Scopus Q2
Journal
CERAMICS-SWITZERLAND5(3) · pp.562 · 2022
Citation
Scopus 11
FWCI (Scopus)
0.51
ISSN
2571-6131

Authors

  1. Zhang, SinuoFirst authorAdvanced Materials Engineering, University of Science and Technology (UST), Daejeon, 34113, Korea
  2. Sutejo, Imam AkbarAdvanced Materials Engineering, University of Science and Technology (UST), Daejeon, 34113, Korea
  3. Kim, JeehwanSchool of Materials Science and Engineering, Pusan National University, Busan 46241, Korea
  4. Choi, Yeong-JinDepartment of Advanced Biomaterials Research, Ceramics Materials Division, Korea Institute of Materials Science (KIMS), Changwon-si, 51508, Korea
  5. Gal, Chang WooDepartment of Advanced Biomaterials Research, Ceramics Materials Division, Korea Institute of Materials Science (KIMS), Changwon-si, 51508, Korea
  6. Yun, Hui-SukCorresponding authorAdvanced Materials Engineering, University of Science and Technology (UST), Daejeon, 34113, Korea

Abstract

© 2022 by the authors.Mica is a group of clay minerals that are frequently used to fabricate electrical and thermal insulators and as adsorbents for the treatment of cationic pollutants. However, conventional subtractive manufacturing has the drawback of poor three-dimensional (3D) shape control, which limits its application. In this study, we propose digital light processing (DLP)-based additive manufacturing (AM) as one of the most effective ways to address this drawback. Two major challenges for the ceramic DLP process are the production of a homogeneous and stable slurry with the required rheological properties and the maintenance of printing precision. The mica green body was fabricated using a 53 vol.% solid loading slurry through DLP, which exhibited good dimensional resolution under an exposure energy dose of 10 mJ/cm2. The precise, complex 3D structure was maintained without any defects after debinding and sintering at 1000 °C. The use of ceramic AM to overcome the shape-control limitations of mica demonstrated in this study offers great potential for expanding the applications of mica.

Keywords

additive manufacturingclay mineralsdigital light processingmica

Identifiers

Scopus EID
2-s2.0-85138712808