Skip to content

Influence of preliminary metal-ion etching on the topography and mechanical behavior of TiAlN coatings on cemented carbides

Document Type
Publications · Journal Article
Registered DB
SCIEScopus
Journal Ranking
JCR Q1Scopus Q1
Citation
Web of Science 35Scopus 38
FWCI (Scopus)
2.24
JCR IF
JCR 2021 4.865
ISSN
0257-8972

Authors

  1. Peng, BinFirst authorGuangdong Univ Technol, Sch Electromech Engn, Guangzhou 510006, Peoples R China
  2. Xu, Yu X.Corresponding authorGuangdong Univ Technol, Sch Electromech Engn, Guangzhou 510006, Peoples R China
  3. Du, Jian W.Cent South Univ, State Key Lab Powder Met, Changsha 410083, Peoples R China
  4. Chen, LiCent South Univ, State Key Lab Powder Met, Changsha 410083, Peoples R China
  5. Kim, Kwang HoPusan Natl Univ, Global Frontier R&D Ctr Hybrid Interface Mat, Busan 609735, South Korea
  6. Wang, Qi MinCorresponding authorGuangdong Univ Technol, Sch Electromech Engn, Guangzhou 510006, Peoples R China

Abstract

© 2022 Elsevier B.V.Metal-ion etching is widely used in substrate surface modification before coating by physical vapor deposition. In this work, TiAlN coatings were synthesized onto cemented carbides with Ti-, Cr-, and Zr-ion pre-etching by cathodic arc evaporation and investigated concerning surface topography and mechanical failure. The pre-etching of energetic metal ions introduces droplet defects and increases surface roughness through uneven bombardment. The high interface roughness and deposition of nanoscale metal interlayers contributed to the upgraded adhesion between the coating and the substrate. As a result, the adhesion strength of TiAlN coatings advances to more than 95 N by applying Cr- and Zr-ion pre-etching. The rough substrate surface also gives rise to a rough coating surface associated with the pre-etching time. Under normal loading, the microscopic pit-like surface morphology, stemming from ion etching, interrupts the transverse propagation of the circumferential cracks but does not affect the longitudinal crack propagation inside the coating. In addition, the higher roughness of coatings with ion pre-etching causes a shorter run-in stage during ball-on-disc tests due to the higher contact stress between the friction pair.

Keywords

Crack propagationDry frictionIon etchingScratch adhesionSurface topographyHIGH-SPEED STEELSCRATCH ADHESIONHARD COATINGSCUTTING PERFORMANCESURFACE-TOPOGRAPHYRESIDUAL-STRESSESDROPLET FORMATIONNITRIDE COATINGSGROWTH DEFECTSTIN COATINGS

Identifiers

Scopus EID
2-s2.0-85122464321
WoS UID
000782697200003