Evaluation method of the light-trapping structure for a transparent thin-film silicon solar cell with low-illuminance condition
- Document Type
- Publications · Journal Article
- Registered DB
- SCIEScopus
- Journal Ranking
- JCR Q2Scopus Q1
- Journal
- SOLAR ENERGY231 · pp.1107 · 2022
- Citation
- Web of Science 8Scopus 9
- FWCI (Scopus)
- 0.4
- JCR IF
- JCR 2021 7.188
- ISSN
- 0038-092X
Authors
- Choi, Soo-WonFirst authorPusan Natl Univ, Dept Mat Sci & Engn, Busan 46241, South Korea
- Park, Jae-HoKorea Inst Mat Sci, Surface Mat Div, Chang Won 51508, Gyeongnam, South Korea
- Kim, Ji-HoonKorea Inst Mat Sci, Surface Mat Div, Chang Won 51508, Gyeongnam, South Korea
- Kim, YonghunKorea Inst Mat Sci, Surface Mat Div, Chang Won 51508, Gyeongnam, South Korea
- Song, PungkeunCorresponding authorPusan Natl Univ, Dept Mat Sci & Engn, Busan 46241, South Korea
- Shin, MyunhunCorresponding authorKorea Aerosp Univ, Sch Elect & Informat Engn, Goyang 10540, Gyeonggi, South Korea
- Kwon, Jung-DaeCorresponding authorUniv Sci & Technol UST, Dept Adv Mat Engn, 217 Gajeong Ro, Daejeon 34113, South Korea
Abstract
© 2021Transparent hydrogenated amorphous silicon (a-Si:H) thin-film solar cells were fabricated for building-integrated photovoltaic (BIPV) windows, and light-trapping structures were formed on aluminum-doped zinc oxide (ZnO:Al) front electrodes to increase the output current and power under low-irradiance conditions in buildings. The degree of light-trapping was controlled by varying the etching time for texturing the ZnO:Al electrodes. As the etching time increased from 5 to 20 s, the surface area and average haze increased from 102.02 to 116.27 μm2, and 3.4 to 14.6% in the absorption wavelength range of 400–600 nm, respectively. The introduction of the light-trapping structure can increase the photogenerated current but causes defects in the cell. The current and defect density both depend on the light intensity; the highest power conversion efficiency of the cell was obtained in different light-trapping structures depended on the light intensity. To evaluate the light-trapping effect independent of the light intensity, we theoretically derived the effective absorbance and current density loss parameters using rate equations, which were in good agreement with the measurements. The presented methods can be applied to various thin-film solar cells requiring light-trapping structures to effectively utilize low-illuminance conditions.
Keywords
Building-integrated photovoltaicsEtchingHydrogenated amorphous siliconLight intensityTransparentTEXTURESURFACEENERGYEFFICIENTLAYER
Identifiers
- Scopus EID
- 2-s2.0-85121923592
- WoS UID
- 000754384100003



Login
Back to Publication list