Skip to content

Microstructures and Mechanical Properties of Reduced-activation Ferritic/Martensitic (RAFM) Steels with Ti Substituted for Ta

Ta 첨가원소 대체 Ti 첨가형 저방사화 페라이트/마르텐사이트 강의 미세조직과 기계적 특성

Document Type
Publications · Journal Article
Registered DB
KCI
Journal
열처리공학회지30(2) · pp.53 · 2017
Citation
KCI 0
ISSN
1225-1070

Authors

  1. Woo-Kyoung SeolFirst author부산대학교
  2. 이창훈Corresponding author한국기계연구원부설 재료연구소
  3. 문준오한국기계연구원부설 재료연구소
  4. 이태호한국기계연구원부설 재료연구소
  5. 장재훈한국기계연구원부설 재료연구소
  6. Kang, NamhyunCorresponding author부산대학교

Abstract

The aim of this study is to examine a feasibility to substitute Ti for Ta in reduced activation ferritic/martensitic (RAFM) steel by comparing a Ti-added RAFM steel with a conventional Ta-added RAFM steel. The microstructures and mechanical properties of Ta-, and Ti-added RAFM steels were investigated and a relationship between microstructures and mechanical properties was considered based on quantitative analysis of precipitates in two RAFM steels. Ta-, and Ti-added RAFM steels were normalized at 1000~1040oC for 30 min and tempered at 750oC for 2 hr. Both RAFM steels had very similar microstructures, that is, typical tempered martensite with relatively coarse M23C6 carbides at boundaries of grain and lath, and fine MX precipitates inside laths. The MX precipitates were identified as TaC in Ta-added RAFM steel and TiC or (Ti, W)C in Ti-added RAFM steel, respectively. It is believed that these RAFM steels show similar tensile and Charpy impact properties due to similar microstructures. Precipitate hardening and brittle fracture strength calculated with quantitative analysis of precipitates elucidated well the similar behaviors on the tensile and Charpy impact properties of Ta-, and Ti-added RAFM steels.

Keywords

RAFM steelTiMicrostructuresMechanical propertiesPrecipitate

Identifiers

KCI
ART002216771