Skip to content

Improved Electrical Performance of SiO2-Doped Indium Zinc Oxide Thin-Film Transistor

Document Type
Publications · Journal Article
Registered DB
SCIE
Journal
JOURNAL OF NANOSCIENCE AND NANOTECHNOLOGY19(3) · pp.1470 · 2019
Citation
Web of Science 5
JCR IF
JCR 2018 1.093
ISSN
1533-4880

Authors

  1. Lim, YooseongFirst author부산대학교, 공과대학, 전기전자공학부, 전자공학전공, KO
  2. Hwang, Namgyung부산대학교, 공과대학, 전기전자공학부, 전자공학전공, KO
  3. Lee, Jeongseok부산대학교, 공과대학, 전기전자공학부, 전자공학전공, KO
  4. Se-hyeong Lee부산대학교, 공과대학, 전기전자공학부, 전자공학전공, KO
  5. Yi, MoonsukCorresponding author부산대학교, 공과대학, 전기전자공학부, 전자공학전공, KO

Abstract

In this study, we investigated the effect of oxygen content on the stability and the role of silicon in amorphous SiO2-doped indium-zinc-oxide thin film transistor. The SiO2-doped IZO (SIZO) thin-films were deposited at room temperature by radio-frequency magnetron co-sputtering. To optimize stability and electrical performance, we changed the amount of oxygen by changing oxygen gas ratio in reactive sputtering (11%, 12%, and 13%) and used SiO2 target to deposit SIZO active layer. By adjusting the parameters of SIZO thin-film transistor (TFT) preparation, we found that the best performance was obtained when the oxygen ratio of a-SIZO films was 11%. The optimized a-SIZO TFT exhibited an on/off current ratio (I-on/I-off) of 2.1x10(7), saturation mobility (mu(sat)) of 53.6 cm(2)/V.s, threshold voltage (Vth) of -7.3 V, and subthreshold swing (S.S.) of 1.7 V/decade. Compared to a-IZO films, the a-SIZO film showed better stability and electrical performance because it had fewer oxygen vacancies and defects.

Keywords

Oxide TFTSi-IZORf-Magnetron SputterStability

Identifiers

WoS UID
000450899000041