Pyrrole N-alkyl side chain effects on the properties of pyrrolo[3,4-c]pyrrole-1,3-dione-based polymers for polymer solar cells
- Document Type
- Publications · Journal Article
- Registered DB
- SCIEScopus
- Journal Ranking
- JCR Q2Scopus Q1
- Journal
- NEW JOURNAL OF CHEMISTRY42(14) · pp.12045 · 2018
- Citation
- Web of Science 6Scopus 6
- FWCI (Scopus)
- 0.26
- JCR IF
- JCR 2017 3.201
- ISSN
- 1144-0546
Authors
- Tamilavan, VellaiappillaiFirst authorDepartment of Physics, Pukyong National University, Busan, South Korea
- Lee, JihoonDepartment of Physics, Pukyong National University, Busan, South Korea
- Lee, Dal YongDepartment of Physics, Pukyong National University, Busan, South Korea
- Agneeswari, RajalingamDepartment of Industrial Chemistry, Pukyong National University, Busan, South Korea
- Jung, Yun KyungSchool of Biomedical Engineering, Inje University, Gimhae, South Korea
- Jin, YoungeupDepartment of Industrial Chemistry, Pukyong National University, Busan, South Korea
- Jeong, Jung HyunDepartment of Physics, Pukyong National University, Busan, South Korea
- Hyun, Myung HoDepartment of Chemistry, Pusan National University, Busan, South Korea
- Park, Sung HeumCorresponding authorDepartment of Physics, Pukyong National University, Busan, South Korea
Abstract
In this study, two new pyrrolo[3,4-c]pyrrole-1,3-dione (PPD)-based polymers (P3 and P4) incorporating a 2-octyldodecyl (branched alkyl) group on the pyrrole nitrogen of the PPD unit were prepared. Their properties were briefly compared to those of the structurally quite similar PPD-based polymers (P1 and P2) with an n-octyl (linear alkyl) group on the PPD unit, in order to understand the importance of the pyrrole N-alkyl group. The calculated optical band gaps (E-g) and highest occupied molecular orbital energy levels of P3 and P4 were found to be around approximate to 0.1 eV higher and deeper, respectively, compared to those of the respective linear alkylated polymers P1 and P2. The maximum power conversion efficiency (PCE) obtained for the polymer solar cells made by using P3 or P4:PC70BM blends without any additive was around approximate to 2%, which was quite similar to that of the PSCs made using P1 or P2:PC70BM blends. However, P3 and P4 exhibited a notably lower PCE than that of P1 and P2, respectively, when the polymer solar cells were created with an additive. This study confirmed that the alkyl substituent on the pyrrole nitrogen of the PPD unit significantly affects the properties of the resulting polymer.
Keywords
BAND GAP POLYMERCONJUGATED POLYMERSEFFICIENTUNITSBENZODITHIOPHENECOPOLYMERSDONORPERFORMANCEDERIVATIVESMODULATION
Identifiers
- Scopus EID
- 2-s2.0-85049740541
- WoS UID
- 000438394800097



Login
Back to Publication list