Skip to content

Mechanism of Electrospinning for Poly(amic acid)/Polyacrylonitrile Fiber Fabrication

Document Type
Publications · Journal Article
Registered DB
SCIEScopus
Journal Ranking
JCR Q3Scopus Q2
Citation
Web of Science 12Scopus 14
FWCI (Scopus)
0.52
JCR IF
JCR 2017 1.005
ISSN
0022-2348

Authors

  1. Choi, SejinFirst authorDepartment of Organic Material Science and Engineering, Pusan National University, Busan, South Korea
  2. Kim, Hye RiDepartment of Organic Material Science and Engineering, Pusan National University, Busan, South Korea
  3. Jeong, Yu KyungDepartment of Organic Material Science and Engineering, Pusan National University, Busan, South Korea
  4. Bang, Ju YupDepartment of Organic Material Science and Engineering, Pusan National University, Busan, South Korea
  5. Kim, HanseongCorresponding authorDepartment of Organic Material Science and Engineering, Pusan National University, Busan, South Korea

Abstract

A poly(amic acid) (PAA) solution in xylene was prepared for electrospinning in order to fabricate fibers. However, jet breaking occurred at the point of the occurrence of whipping instability, resulting in forming micro-particles. This was an exceptional jet behavior compared with the general electro-spraying process that occurs directly from the surface of the polymer droplet. It is important to understand the mechanism of electrospinning and the instability of PAA in order to form fibers for mat deposition. Thus, the behavior of the jet breaking was clearly observed by a high-speed camera and the dynamic behavior of the jet was explored by an image analysis technique. Furthermore, polyacrylonitrile (PAN) was added to the PAA/xylene solution with various concentrations to change the elongation viscosity. Uniform diameter fibers were obtained by increasing the content of PAN to the level that the drag force between the polymer chains increased enough to overcome the drawing force. As a result the optimum content ratio of the PAA/PAN mixed solution to obtain the desired fiber spinning and deposition was determined as being 5:5.

Keywords

Electrospinningfiber depositionjet breakingjet behaviorpoly(amic acid)whipping instabilityBENDING INSTABILITYPOLYMER NANOFIBERSHUMIDITY SENSORSCOMPOSITEMEMBRANESPOLYANILINEPERFORMANCEFILMSJETS

Identifiers

Scopus EID
2-s2.0-85043304864
WoS UID
000429989200005