Enhanced Mechanical Properties by Directional Solidification and Cold Drawing in Cu Added Zn-Al Alloys
Cu가 첨가된 Zn-Al 합금에서 일방향응고 및 냉간인발에 따른 기계적 특성 향상
- Document Type
- Publications · Journal Article
- Registered DB
- KCISCIEScopus
- Journal Ranking
- JCR Q2Scopus Q2
- Journal
- Korean Journal of Metals and Materials55(8) · pp.529 · 2017
- Citation
- Web of Science 1Scopus 1KCI 0
- FWCI (Scopus)
- 0
- JCR IF
- JCR 2015 1.36
- ISSN
- 1738-8228
Authors
- Jeong, Hae ChangFirst authorDepartment of Materials Science and Engineering, Changwon National University, Changwon, South Korea
- Kim, Min SooDepartment of Materials Science and Engineering, Changwon National University, Changwon, South Korea
- Ahn, Jee HyukCommercialization Research Division, Korea Institute of Materials Science, Changwon, South Korea
- Lim, Sung HwanDepartment of Nano Applied Engineering, Kangwon National University, Chuncheon, South Korea
- Han, Seung ZeonCorresponding authorCommercialization Research Division, Korea Institute of Materials Science, Changwon, South Korea
- Lee, JehyunDepartment of Materials Science and Engineering, Changwon National University, Changwon, South Korea
- Kim, Kwang HoSchool of Materials Science and Engineering, Pusan National University, Pusan, South Korea
Abstract
The lamellar structure of two phases, the Zn-rich and Al-rich phases, is formed in a Zn-5 wt% Al eutectic alloy. In order to study the effect of microstructural changes on the tensile properties of eutectic Zn-Al binary alloy, Zn-Al and Zn-Al-Cu alloys were directionally solidified at a growth rate of 50 mu m/s using a Bridgman-type method. The alloys were successively drawn until reaching area reductions of 50% and 80% at room temperature. The tensile strength of the Zn-Al alloy decreased with increasing drawing ratio. In the Zn-Al-Cu alloy, the tensile strength increased until the area reduction reached 50%, but decreased at an area reduction of 80%. The ductility of alloys prepared by directional solidification increased with increasing drawing ratio. The orientations of the lamellar structure and grains were aligned in the drawn direction. The inter-lamellar distance of the alloys also decreased with increasing drawing ratio. As a result, the trade-off between strength and ductility could be significantly reduced. The strength and ductility combination of 246 MPa-40% was achieved by cold drawing with 80% area reduction of the Zn-Al-Cu alloy.
Keywords
eutecticZn-Al alloydirectional solidificationhigh strengthhigh ductilityROOM-TEMPERATURE SUPERPLASTICITYGRAIN-REFINEMENTSI ALLOYSMG ALLOYMICROSTRUCTURESTRENGTHPRECIPITATIONDEFORMATIONCOMPOSITESEVOLUTION
Identifiers
- Scopus EID
- 2-s2.0-85027458226
- WoS UID
- 000406987600001
- KCI
- ART002248127



Login
Back to Publication list