Experimental Investigation on Galling Performance of Tool Steel in Stamping of UHSS Sheets
- Document Type
- Publications · Journal Article
- Registered DB
- KCISCIEScopus
- Journal Ranking
- JCR Q2Scopus Q1
- Journal
- INTERNATIONAL JOURNAL OF PRECISION ENGINEERING AND MANUFACTURING15(6) · pp.1101 · 2014
- Citation
- Web of Science 12KCI 3
- JCR IF
- JCR 2013 1.5
- ISSN
- 2234-7593
Authors
- Choi, Hong-seokFirst author부산대학교, 공과대학, 기계공학부, KO
- Kim, Sung-Gwi부산대학교, 부속연구소, KO
- Seo, Pan-KiShinyoung Co Ltd, Tech Res Inst, KO
- Kim, Byung Min부산대학교, 공과대학, 기계공학부, 정밀가공시스템전공, KO
- Cha, Byung-Chul한국생산기술연구원, Dongnam Reg Div, KO
- Ko, Dae-CheolCorresponding author부산대학교, 나노과학기술대학, 나노메카트로닉스공학과, KO
Abstract
The objective of this study is to experimentally investigate the effect of surface roughness parameters on the galling performance of tool steel used in the stamping of ultra-high-strength steel (UHSS) sheets. The galling performance of uncoated and TiAlCrN coated AISI D2 tool steel was evaluated against a 1.4 mm-thick dual phase (DP) 980 UHSS sheet, using pin-on-flat surface test. For evaluating the galling performance of tool steel, the surface roughness parameters and topography were tested under three surface conditions: as-received (AS), as-received and post-polished (AS+P), and as-received coating (AS+C), whereas the sheet surface was tested under as-received and no post-treatment surface condition. The variation in the coefficient of friction was monitored as a function of sliding distance. The sliding distance at which severe galling began to occur owing to the transfer of sheet material to the tool surface was determined as the critical sliding distance for a sudden increase in the friction coefficient. Experimental results showed that a plateau-like topography, with low average surface roughness, negative skewness and high kurtosis value, improved the galling performance of tool steel. Additionally, the hard TiAlCrN coating of tool surface also effectively reduced galling tendency.
Keywords
Galling performanceFriction coefficientSurface roughness parameterTool steelUltra high strength steel sheetStampingHIGH-STRENGTH STEELSSURFACE-ROUGHNESSWEARPARAMETERSRESISTANCEMECHANISMSCOATINGS
Identifiers
- WoS UID
- 000337119500020
- KCI
- ART001879432



Login
Back to Publication list