Fabrication of micro spur gears by step powder extrusion of Zn-22wt%Al powder without sintering process
- Document Type
- Publications · Journal Article
- Registered DB
- KCISCIEScopus
- Journal Ranking
- JCR Q3Scopus Q2
- Journal
- JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY27(1) · pp.163 · 2013
- Citation
- Web of Science 2
- JCR IF
- JCR 2012 0.616
- ISSN
- 1738-494X
Authors
- LEE, Kyung-HunFirst author부산대학교, 부속연구소, Precis Mfg Syst Div, 소성가공, KO
- Lee, Jung-Min한국생산기술연구원, Dongnam Reg Div, KO
- Kim, Dong-Hwan한국국제대학교, KO
- Kim, Byung MinCorresponding author부산대학교, 공과대학, 기계공학부, 정밀가공시스템전공, KO
Abstract
Micro spur gears were fabricated using the LIGA process and step powder extrusion without sintering. It is important to manufacture micro dies with high aspect ratios and determine the appropriate extrusion conditions for the micro-forming process. Micro-extrusion dies with close tolerance and long bearing length were produced by the LIGA process. Superplastic Zn-22wt%Al powders can deform under low stresses and exhibit a good micro-formability (average strain rate: 10(-3)s(-1); constant temperature: 250A degrees C). These powders were compacted to a cylinder (diameter: 3 mm; height: 10 mm) under 10kN compressive force, and sintered at 350A degrees C for two hours. Micro spur gear shafts were not produced upon extrusion because of the high working pressure on the die surface. For the reduction of the forming load, step powder extrusion was carried out on the compacted powder without a sintering process, but controlling the temperature dwelling period. This process has succeeded in fabricating micro-gear shafts.
Keywords
LIGA processMicro dieGA Zn-22wt%AlStep powder extrusionMicro spur gearTECHNOLOGYSYSTEMSAL
Identifiers
- WoS UID
- 000313795000019



Login
Back to Publication list